Biesse Rover error- Present sensor lacking


Results 1 to 4 of 4

Thread: Biesse Rover error- Present sensor lacking

  1. #1
    Registered
    Join Date
    Aug 2011
    Location
    England
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Biesse Rover error- Present sensor lacking

    Hi there,

    We have a Biesse Rover A 3.30 K4 and have an error message coming up.

    Error message- PLC9046> Slot tool- present sensor lacking (1 in 52)

    We have started the machine as usual and carried out calibration. We then loaded a program but the machine fails to pick up the tool (diamond cutter)

    We have had the machine drill small vertical and horizontal holes but when the machine went to pick up a tool bit to trim the panel the error appeared again.

    Many thanks

    Dan

    Similar Threads:


  2. #2
    Registered
    Join Date
    Oct 2007
    Location
    croatia
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default

    you have three sensors in main head you must took a metal sheet that cover them, and you should clean the second or middle, probably is a lot of metal dirt on it but just be careful with it its positioned with micrometers and you should put it back how it was been, and the worst is that is sensor damaged and you will need buy new one

    if you dont find it i can send you picture where to look



  3. #3
    Member For-31's Avatar
    Join Date
    Jan 2020
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by rliovic View Post
    you have three sensors in main head you must took a metal sheet that cover them, and you should clean the second or middle, probably is a lot of metal dirt on it but just be careful with it its positioned with micrometers and you should put it back how it was been, and the worst is that is sensor damaged and you will need buy new one

    if you dont find it i can send you picture where to look
    Can you send me pictures were the sensor are at



  4. #4
    Member For-31's Avatar
    Join Date
    Jan 2020
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by For-31 View Post
    Can you send me pictures were the sensor are at
    Number is 8178813539 send pictures were sensor are at thank you



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Biesse Rover error- Present sensor lacking

Biesse Rover error- Present sensor lacking

Biesse Rover error- Present sensor lacking