- Linz french lathe retrofit with Centroid Acorn
-
Member
Linz french lathe retrofit with Centroid Acorn
Hey
I am in the process of fitting a previously manual lathe with a Centroid Acorn board and Clearpath motors.
This kind of lathe manufactured by Linz, and a smaller model by Haulin, are made of a welded sheetmetal frame, while the slide rides on ground and nitrided 65mm rods. This setup is known for accuracy, stiffness and very small footprint, which I need above all.
Here are a couple of videos - in french though. If this thread shows interest I'll make some english videos.
Thanks,
Similar Threads:
Last edited by yellow_submarin; 11-04-2019 at 12:48 PM.
-
- Linz french lathe retrofit with Centroid Acorn
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules