Linz french lathe retrofit with Centroid Acorn

Results 1 to 1 of 1

Thread: Linz french lathe retrofit with Centroid Acorn

  1. #1
    Member
    Join Date
    Jun 2012
    Location
    France
    Posts
    31
    Downloads
    0
    Uploads
    0

    Default Linz french lathe retrofit with Centroid Acorn

    Hey

    I am in the process of fitting a previously manual lathe with a Centroid Acorn board and Clearpath motors.

    This kind of lathe manufactured by Linz, and a smaller model by Haulin, are made of a welded sheetmetal frame, while the slide rides on ground and nitrided 65mm rods. This setup is known for accuracy, stiffness and very small footprint, which I need above all.

    Here are a couple of videos - in french though. If this thread shows interest I'll make some english videos.

    Thanks,






    Similar Threads:
    Last edited by yellow_submarin; 11-04-2019 at 01:48 PM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Linz french lathe retrofit with Centroid Acorn

Linz french lathe retrofit with Centroid Acorn

Linz french lathe retrofit with Centroid Acorn