Need Help! Sabre 750 Pendant error


Results 1 to 3 of 3

Thread: Sabre 750 Pendant error

  1. #1
    Member
    Join Date
    Mar 2009
    Location
    Romania
    Posts
    36
    Downloads
    0
    Uploads
    0

    Default Sabre 750 Pendant error

    Hi.
    Can anyone tell me if he encountered this error with Milacron mill pendant and how he solved the problem?
    Thank you

    Sabre 750 Pendant error-20210327_184404-jpg

    Sabre 750 Pendant error-20210327_183631-jpg

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Sabre 750 Pendant error-20210327_184404-jpg   Sabre 750 Pendant error-20210327_183631-jpg  


  2. #2
    Member
    Join Date
    Mar 2009
    Location
    Romania
    Posts
    36
    Downloads
    0
    Uploads
    0

    Default Re: Sabre 750 Pendant error

    Ok... After system load (with pendant fail in Diagnostic) pendant show coords but does not respond.

    Sabre 750 Pendant error-20210328_152711-jpg

    Attached Thumbnails Attached Thumbnails Sabre 750 Pendant error-20210328_152711-jpg  


  3. #3
    Member
    Join Date
    Mar 2011
    Location
    USA
    Posts
    461
    Downloads
    0
    Uploads
    0

    Default Re: Sabre 750 Pendant error

    I have never seen the error message you have on the pendant display, but it clearly is failing the diagnostic test. There isn't much inside the pendant that is field serviceable so it will likely need to be repaired/replaced,

    I have seen many pendants fail after the cable is damaged though, so check to see if there is any evidence the cable has been crushed or cut (that could be causing an open or shorted wire). There is also an extension cable from the DV5 card to the operator's station that could be causing a problem. I can only remember one machine I ran into this though and it was caused by someone working on the machine damaging the connector.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Sabre 750 Pendant error

Sabre 750 Pendant error