- Need Help!- acramatic 2100e Hawk 150 MDI position wrong but program position correct???
-
Member
acramatic 2100e Hawk 150 MDI position wrong but program position correct???
I have a hawk 150 that has been idle for a month now. my father passed away and I inheriated his machine shop. I usually run the kia lathe but need to learn to set up the hawk.
My father has a step by step set up guide for it but my issue is in mdi. When I tell the machine to go to X1.533 it will go way below the part instead of right above it and I don't know why. If the machine is in program mode and I tell it to go to X1.533 it will go right above the part?????? I'm trying to set the z zero but I'm unable to until I figure out why MDI mode is acting this way?
The code he uses for it is
T11 M6
M2
G92 S3000
G0 X1.533
G1 G96 G95 X -032 S500 F.006 M13
G0 X1.533
M0
G92.1 Z0
The instructions will say when to run each part of the program to set z zero.
Similar Threads:
-
-
Member
Re: acramatic 2100e Hawk 150 MDI position wrong but program position correct???
FetterSP,
If you run this code in MDI does it work properly?
:G90G70
; There really should be a line here to move the turret to a clear indexing position
T11 M6; Index to and activate tool #11
G92 S3000; Set a MAX Rpm of 3000 in CSS mode
G0 X1.533
G1 G96 G95 X -.032 S500 F.006 M13 ;Invoke CSS & FPR... Problem --- You were missing the Decimal Point in "X"
G0 X1.533
M2; End of Program - Data Reset and Rewind
- Need Help!- acramatic 2100e Hawk 150 MDI position wrong but program position correct???
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules