Acramatic 950 "M98" Looping?

[Ox1]

I ran a search and found zero threads with "950" in the title.
Shirley that's not true?


On my old A900 control, you could program a sub like:

(CLS, I1, L3) .. or something like that to indicate that you wanted to cycle sub 1 three times.

However, on the 950, I cannot figger out how to cycle a sub more than once per call.


I may have asked this here somewhere before, but I don't find anything ...

Similar Threads:

• Acramatic 2100 control Error 39-6 and pendant z axis drive "not ready"
• New Machine Build- How can do ""manual stepper motor sizing for "rack and pinion"calculation""???
• Acramatic 950 " System Failure 01026 " upon startup
• LinuxCnc "Step Time" "Step Space" "Direction Hold" "Direction Setup" values??
• Problem- X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"

[meckardt55]

Send us an e-mail

MIKE CNC Machine Services INC | Cincinnati Milacron MachinesCNC Machine Services

[hmtr]

I don't think you can do that on the 950 control.
You have to use T registers and a counter.

~beginning of part program
G10=[T1]V0
Q100
(CLS,L10)
G10=[T1]V[T1]+1
G11E[T1]<3L-100
~rest of part program

[Ox1]

I don't think you can do that on the 950 control.
You have to use T registers and a counter.

~beginning of part program
G10=[T1]V0
Q100
(CLS,L10)
G10=[T1]V[T1]+1
G11E[T1]<3L-100
~rest of part program

OK - I may try that the next time.
THANKS!

[Ox1]

Much obliges!

The macro format worked!