ALIGN TOOL CHANGER


Results 1 to 3 of 3

Thread: ALIGN TOOL CHANGER

  1. #1
    Member
    Join Date
    Oct 2008
    Location
    USA
    Posts
    12
    Downloads
    1
    Uploads
    0

    Default ALIGN TOOL CHANGER

    I have a Arrow 750 with a 2100 control. I power the machine up and align the axis all works fine. When I attempt to align the tool changer it gives me a message that the tool changer is disabled. I have not been able to find out how to enable it. please help

    Similar Threads:


  2. #2
    Member
    Join Date
    Apr 2004
    Location
    Canada
    Posts
    347
    Downloads
    0
    Uploads
    0

    Default

    Try looking around in the machine settings somewhere, I think "Machine Applications" should be the right area. To change stuff you will need to enter the password "worldclass" in order to be able to alter things. Be careful what you change though.

    I think I have seen somewhere in there before a selection to enable/disable the toolchanger. Then again I may be totally wrong

    Make sure to change password back to either "setup" or "operator" when you're done.



  3. #3
    Member
    Join Date
    Oct 2008
    Location
    USA
    Posts
    12
    Downloads
    1
    Uploads
    0

    Default Re: ALIGN TOOL CHANGER

    That fixed me up. Thank you



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

ALIGN TOOL CHANGER

ALIGN TOOL CHANGER