- ALIGN TOOL CHANGER
-
Member
ALIGN TOOL CHANGER
I have a Arrow 750 with a 2100 control. I power the machine up and align the axis all works fine. When I attempt to align the tool changer it gives me a message that the tool changer is disabled. I have not been able to find out how to enable it. please help
Similar Threads:
-
-
Member
Try looking around in the machine settings somewhere, I think "Machine Applications" should be the right area. To change stuff you will need to enter the password "worldclass" in order to be able to alter things. Be careful what you change though.
I think I have seen somewhere in there before a selection to enable/disable the toolchanger. Then again I may be totally wrong
Make sure to change password back to either "setup" or "operator" when you're done.
-
Member
Re: ALIGN TOOL CHANGER
That fixed me up. Thank you
- ALIGN TOOL CHANGER
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules