Seek advice on dial gauge with low "measuring force" ...

[evalon]

Hi All,

I have a question that hopefully is not too complicated - and which I hope one of you may help give a bit of advice about ...

As it is I am currently working with quite small & delicate parts that easily bend - yet I still need them to be very precise. To check this I now use a Käfer dial gauge (German) and normally is quite content with the way it works and its basic precision.

However, when working with these small parts the Käfer dial gauge´s measuring force is so high (0.7N) that it visibly bends the parts. So I need to find a dial gauge with a significantly lower measuring force (likely ~ ten times lower), same precision, about 5mm of measuring range, preferably second hand - but I don't know if this exists nor where to look for it ...

Might one of you here be able to advice on this (would be appreciated)?

Cheers & thanks,

Jesper

Similar Threads:

• Mititoyo Digimatic Hotetest Gauge Series 468 .8" to 2"
• Need Help!- SOS / help : fanuc 15T system with "OT007 z+ overtravel (Hard) alarm" FORCE sIGNaL
• "ANILAM" DIGITAL READOUT SCALE LINEAR ENCODER - MEASURING LENGTH 15.5" (mi 91.0)
• 0-1", 1-2" dial micrometer .00005" suhl feinmesszeugfabrik ddr 2

[2COOL585]

maybe you'ld want to look at Deltronic pins? Then you can decide how much "force: to use.

[evalon]

@2Cool585: Thanks for your feedback but as far as I can see it is a "passive" device - I need to be able to mount it on my CNC mill and then run it over the relevant surfaces - yet with a low measuring force.

I cannot see that I can use these pin for that - or am I missing something?

Cheers,

Jesper