z axis switch doesn't work on homing
Member
z axis switch doesn't work on homing
i've purchased and assmebled a generic 3018 chinese CNC
i've added limit switches, and changed the settings, hard limits are on, and all switches work without any issue
the problem is homing, when i try homing, z axis goes up and the switch doesn't make it stop and just keeps spinning
Thanks in advance for any help
Member
Re: z axis switch doesn't work on homing
If you are using latest firmware, i had issues with woodpecker board, to use homing i bought an MKS DLC. some pins on arduino clones were repurposed in later grbl versions....
z axis switch doesn't work on homing
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules