6040 error code and spindle not working. Help!

[Gom]

Well I ended up just getting a new VFD and will run the spindle manually.

But I don't know how to program it for my spindle. Any help?

Spindle info:Power: 1.5KW
Voltage: 220V
Frequency: 0-400HZ
Speed: 0-24000RPM

See pics for the VFD manual.

Hopefully someone can help me. I changed a couple of parameters that I thought might be the way to go and tried it. The spindle starts up and spins but quickly (1 second) gives me an error 1 (short circuit/current overload/power module protection). So obviously didn't do it right.

[mactec54]

Thanks....i need to see all the terminals to make out the writing. Also need to see any switches on the pc board

You are looking at them in this photo show them clearly, that is the complete open board VFD Drive these machines have Power in Power out to spindle it's all connected correct, the only thing missing is the Ground wiring which is normal for these machines, which need to be rewired with Ground wires

Programing is usually what these machines have problems with

[mactec54]

Well I ended up just getting a new VFD and will run the spindle manually.

But I don't know how to program it for my spindle. Any help?

Spindle info:Power: 1.5KW
Voltage: 220V
Frequency: 0-400HZ
Speed: 0-24000RPM

See pics for the VFD manual.

Hopefully someone can help me. I changed a couple of parameters that I thought might be the way to go and tried it. The spindle starts up and spins but quickly (1 second) gives me an error 1 (short circuit/current overload/power module protection). So obviously didn't do it right.

Is this an AT1 Drive need the Drive Name Spec's

[Gom]

Aiight. I got it working. Thanks to those who tried to help.

I will upload my current parameters later in case anyone else finds this thread in the future.