i have a cnc router and i am cut thin plastic so i am running at 100" min the cut is good. when it goes to finish the circle the machine pulls out about 3/8" early leaving a gap of unfinished plastic. i am using artcam pro. mach3 i have another cut which is only about an inch long and when i slowed down the cut to 30" min it cut complete but i dont want to slow the other cuts because they run to long.
btw the cut is .080 bit .090 deep 100" min like i said before it cuts nice at that speed in fact the cut is worse when i slow it down.
please help todd

Similar Threads: