Hi all
Has anyone successfully made their 6040 with a jp-3163b board and a nowforever vfd gotten it to turn on via the mach3 software. I have already tried the videos on you tube and none of them seem to work with my machine. I really dont care about setting the speed but turning it off and on would be great. Any advice would be appreciated!!
Walt
Similar Threads:
- Need Help!- CNC 6040 spindel control
- Need Help!- CNC 6040 spindel control
- CNC 6040 Control Box Cables
- Need Help!- CNC 6040 VFD spindle control
yes it has a relay, I know that I need to run a wire from the C and NO pins for the relay but do not know where to put the wires to the VFD
The VFD should have the terminals labeled COM (common) and FWD (forward). Sometimes they are called slightly differently, such as DCOM (digital common). Shorting those terminals will start the motor (if the VFD is configured accordingly - see the operation manual for details).
Thanks for that, I will give it a shot when I get home. I appreciate the help!!
I am wrong, when I change the vfd to run off Mach3 it comes on and stays on but when you hit the button it just slows down and goes right back to whatever speed is on the vfd
Last edited by wdp67; 01-18-2019 at 06:15 AM.
Any ideas to try and get it?
yes it will not stop with the M5 or the spindle toggle, just winds down for a few second and then back up to speed, like the relay is shutting off and then switching right back, that is what I am asking for help for I dont know what setting I need to fix.
Without seeing what you have for your Mach3 settings anyone would be just guessing
Post your Mach3 settings Spindle Page, Spindle Ports and pins, Pulley setup, Spindle under motor tuning
Post the code you where using also, it should never be able to turn back on without a signal to switch the relay back on
What model VFD Drive do you have
Mactec54
Ok so in motor outputs spindle
It was enabled step pin was 14 dot was 15 platelets port and dot port both at one.
I changed both step and for to 16 and now the spindle toggles off and o with the button on the screen but m3 or m5 in the MDI line do nothing
Nor does it shut off with hitting the emergency stop button
I can also hear the relay ticking every few seconds