cnc3018 spindle and control board opinions


Results 1 to 2 of 2

Thread: cnc3018 spindle and control board opinions

  1. #1
    Registered
    Join Date
    Feb 2018
    Location
    United Kingdom
    Posts
    21
    Downloads
    1
    Uploads
    0

    Default cnc3018 spindle and control board opinions

    hello everybody i have just registered and congrats on providing this great forum where i too will try and help out where i can.

    for the moment though i am experiencing a couple of issues where i have absolutely no control whatsoever of the alleged 775 spindle motor in this hobby machine.

    firstly i had to build this machine without any instructions or plans or anything as it simply didn't come with any in the box, although everything to build it was there i managed to build it just from looking at images of it. i have used it to make some coasters out of pine and also a plaque i made for my daughter v-carved. anyway on to the problems i have....i am not happy that this spindle operates at one speed which is quite slow that i can almost slow it down to a stop by placing my finger on the spindle motor's rear end. the control board i have is pictured in this post. i am running grbl 0.8 and i have already tried grbl 0.9 and still no spindle control also this control board takes two power supplies one which is 24v in for the motor allegedly and 12v for the X and Y servos.

    perhaps someone can assist or advise and any more information needed i am happy to give you

    Similar Threads:
    Attached Thumbnails Attached Thumbnails cnc3018 spindle and control board opinions-control-board-pic-jpg   cnc3018 spindle and control board opinions-developower-v2-0-pic-jpg   cnc3018 spindle and control board opinions-control-board-pic-2-jpg  


  2. #2
    Registered Dabhaidh's Avatar
    Join Date
    Aug 2004
    Location
    USA
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default Re: cnc3018 spindle and control board opinions

    Anew controller for thes machines is available on Ebay for $25.00
    It only uses one power supply 24 volts @10 Amps.

    cnc3018 spindle and control board opinions-s-l1600-jpg
    https://www.ebay.com/itm/New-3-Axis-...wAAOSwvjdZP3~w



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

cnc3018 spindle and control board opinions

cnc3018 spindle and control board opinions