- Need Help!- Charter Oak IH6000 - runaway table
-
Registered
Charter Oak IH6000 - runaway table
While doing some routing milling, suddenly my table went at full speed in the negative x axis until it hit the external stop. Turned it off, waited, rebooted, same thing. Driving it with Mach Three software, factory installed. When I launch software and reset, the second I try to move table in positive x, it kicks in to negative x movement, then shuts down immediately, because it is already at the stop. Need help isolating the problem. Software? Cabling? Controller?
Similar Threads:
-
-
Member
Re: Charter Oak IH6000 - runaway table
If servo machine. The first thing I would check is the encoder and or cabling for the x motor.
-
Member
Re: Charter Oak IH6000 - runaway table
You might want to disconnect the motor from the axis while you troubleshoot the issue. As vertcnc said if this is a servo system a bad encoder could send it seeking.
Russ
- Need Help!- Charter Oak IH6000 - runaway table
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules