hsmcnc,
Here is a file from my archives. It makes a header plate for a small block chevy cylinder head.
Have Fun
Colin,
I don't know why your disconnecting the ball screw but if you want to take it out an sell it I'm interested in buying it. If you do remove it be very careful to not let the ball nut run off the end of the screw. If you do you'll have a few balls to find.
Bob
hsmcnc,
Here is a file from my archives. It makes a header plate for a small block chevy cylinder head.
Have Fun
Last edited by BetaBob; 11-13-2006 at 03:49 PM. Reason: Incomplete
Bob,
Thanks for the code. Everytime I power down the machine I lose the program I have entered. I assume the battery is dead. I have attached a picture of what I think is the battery on the Orange tabbed board. Can this be replaced? It sure dosen't look good.
Eric
It is very simple to replace. try jameco.com for the battery.
Me too if available please, specnaz157@gmail.com
Taig 2018 Mill
Delta Vh3600