DeskCNC probe


Results 1 to 3 of 3

Thread: DeskCNC probe

  1. #1
    Registered greasetattoo's Avatar
    Join Date
    Mar 2006
    Location
    USA
    Posts
    53
    Downloads
    0
    Uploads
    0

    Default DeskCNC probe

    Hey All,

    Wow, is this Forum DEAD or what??

    I just purchased the DeskCNC probe..
    The documentation is terrible.

    I am doing some scans and everything is coming out at a angle?
    Anyone have any ideas, why?

    See my example below..
    Don't mind the other garbage on the scan.
    The half dollar moved when I was scanning it.
    Just pay attention to the bottom part of the half dollar.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails DeskCNC probe-kennedy-test02-jpg   DeskCNC probe-kennedy-test01-jpg  


  2. #2
    Registered greasetattoo's Avatar
    Join Date
    Mar 2006
    Location
    USA
    Posts
    53
    Downloads
    0
    Uploads
    0

    Default

    Well, I found this info..
    Which helped alot..

    I think IMservice should include these docs with the probe.

    Other then that, seems to be working ok..

    One question though..
    Why would one have different steps for the X and Y.
    Why not keep them the same?

    The example of the quarter, they have the X steps at 100 and the Y steps at 275.



  3. #3


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

DeskCNC probe

DeskCNC probe