is there a bug in ID turning allowances?


Results 1 to 2 of 2

Thread: is there a bug in ID turning allowances?

  1. #1

    Join Date
    Mar 2020
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default is there a bug in ID turning allowances?

    Hello there my name is John and i would like to see if anyone else is having the same issue
    in ID turning at roughing when you give some allowance it gives it towards to the OD
    so i have tryied with a negative number and it works!
    BUT in the simulation it shows the piece with negative allowance! does anyone else have the same problem? is there any solution?

    Also i need one more advice
    when in roughing.... there is always one last pas extra like a "cleaning" pass that doesnt cut any material... how can i get rid of it?

    thank you all and sorry for my english



  2. #2
    Member vincent.pomerleau's Avatar
    Join Date
    Feb 2010
    Location
    Canada
    Posts
    69
    Downloads
    3
    Uploads
    0

    Default Re: is there a bug in ID turning allowances?

    Never had this issue with allowance, I put it in positive and it leave material (OD & ID)... for the rough cycle, you can set the final cut amount to zero and no cleanup will be generated



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

is there a bug in ID turning allowances?

is there a bug in ID turning allowances?