Does any one know how to do this?
Is there anyway to get this down to one pass? The cutter is 1" and even when I shrink the flat width to .3" I get two columns. I just want one path right down the middle. I don't feel this should be that complicated but I can't figure it out.
I have tried several different combination of contain and avoid area. I am using a face feature since a boss feature doesn't have a plunge rough option.
Can you post a screen shot of what your trying to do
I am trying to remove this boss with plunge rough, with one pass down the middle. I can only get it to where is goes down one edge and back up the other, two passes.