Plunge rough down to one pass?


Results 1 to 3 of 3

Thread: Plunge rough down to one pass?

  1. #1
    Member sundewzer's Avatar
    Join Date
    May 2019
    Posts
    27
    Downloads
    0
    Uploads
    0

    Angry Plunge rough down to one pass?

    Is there anyway to get this down to one pass? The cutter is 1" and even when I shrink the flat width to .3" I get two columns. I just want one path right down the middle. I don't feel this should be that complicated but I can't figure it out.

    I have tried several different combination of contain and avoid area. I am using a face feature since a boss feature doesn't have a plunge rough option.



  2. #2
    Member sundewzer's Avatar
    Join Date
    May 2019
    Posts
    27
    Downloads
    0
    Uploads
    0

    Default

    Does any one know how to do this?



  3. #3
    Member
    Join Date
    Jan 2014
    Location
    United States
    Posts
    25
    Downloads
    0
    Uploads
    0

    Default Re: Plunge rough down to one pass?

    Can you post a screen shot of what your trying to do



  4. #4
    Member sundewzer's Avatar
    Join Date
    May 2019
    Posts
    27
    Downloads
    0
    Uploads
    0

    Default

    I am trying to remove this boss with plunge rough, with one pass down the middle. I can only get it to where is goes down one edge and back up the other, two passes.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Plunge rough down to one pass?

Plunge rough down to one pass?

Plunge rough down to one pass?