Need Help!- setting 4th axis tilted for clearance
Member
setting 4th axis tilted for clearance
I need to tilt my 4th axis for clearance so that i can get closer to a flange I have ball end mill work on a cone
i need to be able to tilt the 4th in Camworks so i have clearance any one able to point me in the right direction
its almost like having a 5th axis that is locked to a certain degree
I just need a little guidance
thanks Similar Threads:
Member
Re: setting 4th axis tilted for clearance
You'll need to draw a plane at the desired angle and create a coordinate system and new operation on that same plane to use.
Member
Re: setting 4th axis tilted for clearance
I kind of thought that was the way to go..so I am pursing that technique
thanks for the guidance
Member
Re: setting 4th axis tilted for clearance
If you need some further assistance let me know, I can give you my email if you want to send some files and I can try an guide you in the right direction.
Member
Re: setting 4th axis tilted for clearance
thank you I got it to program as I think it should will be running a test part soon
thanks again
Need Help!- setting 4th axis tilted for clearance
Tags for this Thread
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules