Extract machinable features - all good (hole drill and rough + contour perimeter)
post G-code all ok (TUP 10mm CRB 4FL 2 LOC)
A. When I select TUP 6m CRB 4FL 2 LOC and post process all the tool change information disappears?
BTW i usually remove the rough feature as its not needed, but regardless if it stays or goes once the 6mm instead of the 10mm is selected - only the jobber drill remains??????????
Reply with Quote
Just strange.... - Too change g-code missing
Re: Just strange.... - Too change g-code missing
