Hi Forum,

I am looking to setup my mill for lettering-and icon type diagrams, whilst this project will focus on cast acrylic (like aircraft backlit controls) i suspect i would have the need to expand this to other materials down the track.

Backlit board - cast acrylic (polycarbonate) uses top spray paint coat onto a translucent sheet, the cutter 'cuts' the desired font/logo/ diagram etc and is backlit (illuminated).

Can i do this is Solidworks-camworks or am i better looking for other solutions (please note the job requires both lettering and icons together, so only font solutions my not fit what i am trying to do)

any pointers appreciated

Similar Threads: