edit the post to move the tool list after the program number
How can I do this? right now my post outputs the tool list before the program. I need to list the tools after the start of the program.
I am using this line in my Lib file
:C: GETTOOLS(2,OUTPUT_TOOL_LIST)
and this section in the src file
:SECTION=OUTPUT_TOOL_LIST
:T: TOOL_COMMENT><EOL>
Right now the output is like this
(1/2 EM CRB 2FL 1 LOC)
(1/4 EM CRB 4FL .9 LOC)
%
O0001
N300 (1/2 EM CRB 2FL 1 LOC)
T3M6
should be like this
%
O0001
(T1 1/2 EM CRB 2FL 1 LOC)
(T2 1/4 EM CRB 4FL .9 LOC)
N100(1/2 EM CRB 2FL 1 LOC)
T1M6
Re: edit the post to move the tool list after the program number
I've tried that but it just puts the list after the :SECTION=INIT_TOOL_CHANGE_MILL
I've tried about every location I can and still can't get the right result.
I can't get it to move to just after the :SECTION=START_OF_TAPE
Re: edit the post to move the tool list after the program number
the .lib file I expected was FANCMD.lib , not MILL.lib
Do you make your changes in the MILL.lib file?
If so, do them in the FANCMD.lib and recompile, it should work!
Its better not modifying the mill.lib file, everytime you want to do changes, copy the section you want to modify in (yourpostname).lib and do the mods, it will override the mill.lib same section
Re: edit the post to move the tool list after the program number
I still have the unchanged mill.lib file. I have a fancmd.lib which is the same as the mill.lib I attached. I renamed it to try to get it to work.
I'll try it again with the Fancmd.lib file.
Thanks