Looking good! I trust you also have a hardwired in E-Stop as the screen operated one does not conform to the safety code.
Al
Ok.. I was bored...
It all works great... the buttons turn red yellow and green to indicate function and status..
The lift in the middle moves back and forth over the little green boxes and they also turn colors to indicate function and status.
I had to blur a few things out for obvious reasons.
Comments?
Similar Threads:
Last edited by cncadmin; 04-15-2005 at 07:53 AM.
Looking good! I trust you also have a hardwired in E-Stop as the screen operated one does not conform to the safety code.
Al
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
hmmm wonder if safety codes apply to hobby cnc's?
I don't think it's a "hobby" machine.
http://www.cnczone.com/gallery/showg...&condition=and
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Originally Posted by Al_The_Man
Estops are all hard wired and will cut power to the drives when activated...
I dont trust enable circutes or digital logic.
Murphy
Originally Posted by joe2000che
Hobby what??? who??
This is no hobby machine that's for sure!! Its slightly larger than 2 semi truck trailers. That's one heck of a hobby!! LOL
Murphy