Good company. this one was defective and they sent out a replacement. It's supposed to not need a drain but the the device that puts the condensate into the exhaust was doa. Not good for a server room to have puddle of water on the floor... Garage doesn't care They said cut the cord and toss it but that seemed like a waste and the places that I called to recycle it wanted money.
Richard
EDT: the hose that is going toward the front of the machine actually makes a 180 and I stick it out the garage door to exhaust the hot air out. It keeps the CNC plenty cool and the Mastercool swamp cooler keeps me cool.... well until it gets really hot.
Great solution. I have an injection molding machine next door in a non--airconditioned room. I run it with an outside door open and I added a 4" duct fan from an air conditioned room through the wall directly connected to its control cabinet. It works fine.
Reply with Quote
Cabinet cooling solution
They said cut the cord and toss it but that seemed like a waste and the places that I called to recycle it wanted money.
