Help. VMC TNC370 start up


Results 1 to 2 of 2

Thread: Help. VMC TNC370 start up

  1. #1
    Registered
    Join Date
    Oct 2017
    Location
    United Kingdom
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default Help. VMC TNC370 start up

    Hello, I've taken ownership of a Bridgeport VMC 600 with Heidenhain TNC 370.
    I'm having an issue with getting it to complete the transverse action during start up.
    After a logo, the screen comes up with "power interrupted" and pressing CE moves the screen onto the transverse axis setup, following the instruction manual I should press the button to turn on the control followed by the cycle start button.
    However, when I press these buttons nothing happens, no clicks, no beeps, no movement, nothing.
    The first time I used the machine today it went fine and started just as expected. Only after starting it for the second time I can't get it to work.
    Any ideas?

    Similar Threads:


  2. #2
    Registered
    Join Date
    Oct 2017
    Location
    United Kingdom
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default Re: Help. VMC TNC370 start up

    So after a whole bunch of turning it off, leaving it and turning it on again, it started.
    No idea what happened, but it hasn't happened since.

    moving onto problem number 2... drip feeding the VMC600



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Help. VMC TNC370 start up

Help. VMC TNC370 start up