Erickson QC30 Lock Nut

[Jay Kyle]

Hi all, I'm re-assembling the QC30 lock nut after cleaning it up, but I didn't see how the inner spring and pin are positioned. Can someone who has experience steer me right as whats the right configuration?

1st config


2nd config


3rd config


4th config


Thanks!...Jay



Sent from my iPhone using Tapatalk Pro

Similar Threads:

• Erickson QC30 Holders
• 2UVR with Erickson QC30 spindle
• Boss 3 Conversion - Erickson QC30 Spindle Nut Parts
• Where to buy Erickson quick change QC30 Holders?
• New Erickson QC30 locknut setup

[SvenMjolnir]

Jay,

What did you find out for the configuration#?
I'm in the same boat. Pulled it apart to clean and only found a spring. After searching on the floor found the pin.

Sven

Does anyone know?

[mactec54]

Hi all, I'm re-assembling the QC30 lock nut after cleaning it up, but I didn't see how the inner spring and pin are positioned. Can someone who has experience steer me right as whats the right configuration?



2nd config




Thanks!...Jay



Sent from my iPhone using Tapatalk Pro

2nd config is correct, they can work just fine without the spring and pin also, just have to do it up tight with the wrench

[SvenMjolnir]

Thank you MacTech. I was leaning toward #2 based on the wear marks on the pieces.

Thanks again!

[Jay Kyle]

Thank you MacTech. I was leaning toward #2 based on the wear marks on the pieces.

Thanks again!

It’s been a while since i put it back together, but i do remember working my way through the lockup process to figure it out. Glad macTech’s got it figured