Heidenhain TNC 124 service manual needed

[Tom7227]

Gentlemen,

I am trying to repair an old TNC 124 control unit. It powers up with a overheat error.

Somebody replaced the fan under the control PCB (perhaps maintenance) and did not fix the problem.

I am looking for the thermal measuring circuit.

Thank You

Similar Threads:

• Schematic / service manual needed for Sugino Self Center V8
• CNC Turret Punch Press Machine: Aquilla 1250 service manual needed
• Need Help!- Heidenhain TNC 407 service/repair
• Fanuc service manual(s) needed!
• Service manual needed DWC200

[Tom7227]

I was able to repair this unit, the repair folks at Heidenhain explained that the unit was no longer repairable, but gave me a few tips, It came down to the power supply for the regulated -12 volt and -15 volt missing the supply B+. There are (3) 470 uf caps that leaked slightly on the PCB, and cause enough corrision to disconnect the supply from both regulators.

[MarcoCabezas]

Gentlemen,

I am trying to repair an old TNC 124 control unit. It powers up with a overheat error.

Somebody replaced the fan under the control PCB (perhaps maintenance) and did not fix the problem.

I am looking for the thermal measuring circuit.

Thank You

[pwservice]

Gentlemen,

I am trying to repair an old TNC 124 control unit. It powers up with a overheat error.

Somebody replaced the fan under the control PCB (perhaps maintenance) and did not fix the problem.

I am looking for the thermal measuring circuit.

Thank You

Hi Marco
I’m also looking for the service manual and the software PLC.exe and PLCmon.exe for the TNC 124.
Did you have any luck.
Please share the link if possible.
Thanks.