- Rexroth IndraMotion
-
Hi,
Is anybody familiar with the MTX 10VRS? In particular with the JerkControl ?
I have a problem with the line-by-line ¬milling: with each path adjustment, the feed quickly stops.
G8 and G62 are active.
Program was created using MasterCam.
Many thank in advance
-
-
Registered
Hello Scrats,
Can you post your NC Code.
In principle G8 and G62 are ok.
- Rexroth IndraMotion
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules