- bodor x1006 39x24 inch bed 150 watt 5200 water cooler
-
Member
bodor x1006 39x24 inch bed 150 watt 5200 water cooler
looking for ideas of what could be wrong , as the laser tube is not firing:
--all power supplies are running , green led's showing green, laser tube
power supply fan is running looks ok
--checked the lid switch which has an led
--I bypassed the cooler cw 5200 outlet filter thinking it was restricting the flow
it did not make any difference
--I cleaned the cooler filters which were clean
--i changed the usb cable to the computer made no difference
-- When the usb is connected to the computer the laser moves very slowly and noisy like its in low gear
--pushed the system reset front power voltage 1 reads 4.89volts
--laser runs smooth with no computer hooked up via usb
--computer will not communicate with the laser says it fails, when i try to download or read settings from the laser
--my controller is RDC6442S-B (EC)
--diagnostics off the small screen does nothing
-everything was running fine until the 48v ower supply failed
machine alarm says machine protected
I cannot seem to think of any other permissive to stop the tube firing
any ideas would be welcome, as I seem to be on my own
Similar Threads:
-
-
Member
Re: bodor x1006 39x24 inch bed 150 watt 5200 water cooler
turns out it was a bad relay and controller board has a fault...bodor treats people very badly
they have no respect for customers
its well built but take your chances when you need help
-
Member
Re: bodor x1006 39x24 inch bed 150 watt 5200 water cooler
Bodor promptly shipped me a new 2020 controller and I installed it today and its working good
It was a quick turnaround to get it shipped
appreciate the quick help
- bodor x1006 39x24 inch bed 150 watt 5200 water cooler
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules