You just use the standard Mach3 posts. There's nothing in an Aspire post processor that would be specific to your Romaxx.
Does anyone have a post processor for a Romaxx HS1 in Aspire 4.0 usimg Mach3?
Thanks
Similar Threads:
You just use the standard Mach3 posts. There's nothing in an Aspire post processor that would be specific to your Romaxx.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I upgraded from 3.5 to 4.0 and its adding tool changes to the code and I am using the Mach3 post with no ATC.
also my z has lost its position as I start the the program its shows a t/c and I press start again and the z goes to
the top and and trys to keep on going then it wants to drive to the table.It never did that before I upgraded.I am
new to mach3 and Aspire so it could be error on my part?
What post are you using?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I am using the non ATC Mach3 post.But its adding t/c and wont hold z zero wants to drive out of z limits +and-.
I use aspire4, with mach 3 _ATC and non ATC depending on the project. When I select multiple toolpaths with different tools and non_atc selected, aspire gives me a warning and does not allow saving the file. I must select the ATC processor to proceed. Are you saving multiple toolpaths with different tools into one file?
Sent from my Transformer TF101 using Tapatalk
Yes you just use mach 3 pp for your romaxx mschine...OTE=macatoms;1436012]Does anyone have a post processor for a Romaxx HS1 in Aspire 4.0 usimg Mach3?
Thanks[/QUOTE]
You need to change setting in mach3
...ignore tool change
Thsts what i do...otherwise z will move up 1in and csn cause major issues