Simple 3 axis flowline

[GCSRT]

Toolpath looks good, except the very outside contour that wipes out my whole part. How do you get rid of it?

Similar Threads:

• Flowline Toolpath BobCAM V5
• Newbie- flowline 'tool down' continuity in mastercam 9
• How to create Flowline Toolpath
• Finish Flowline Problem
• flowline plunge

[aldepoalo]

Likely the issue you are having is with one of the toolpath settings. But what you can do to remove that final pass is use a check surface to remove that path. If you would like, pop over in the BobCAD After Dark group and post your question there. Maybe even share the file or some screen shots of your toolpath settings.

This will be a simple fix.

Al

[GCSRT]

Likely the issue you are having is with one of the toolpath settings. But what you can do to remove that final pass is use a check surface to remove that path. If you would like, pop over in the BobCAD After Dark group and post your question there. Maybe even share the file or some screen shots of your toolpath settings.

This will be a simple fix.

Al

Do you have a link to that? I can't find where to post...

[aldepoalo]

[GCSRT]

I meant to the After Dark page...

[aldepoalo]

https://www.facebook.com/groups/bobcadafterdark