Not sure this is a BobCAD issue, I would recommend hitting up the mach group and see what those guys say.
Hey everyone, hope you are all doing great.
I’m having an issue where I will run a program and it will run fine for maybe 1 run, maybe 20 runs. Sooner or later it will get stuck on line 3 and never do anything. If I stop the program and reload it, it won’t work. The only way to get it working again is to reload Mach 3.
I’m calling the gcode that bobcad gives me a “program”.
If it gets stuck on line 3, the status will usually say which end mill I’m using. If I just hit start run again like I would if I changed tools, nothing happens.
I’m not really sure what’s going on. Any help or advice is greatly appreciated.
Similar Threads:
Not sure this is a BobCAD issue, I would recommend hitting up the mach group and see what those guys say.
Al DePoalo
Partner Product Manager BobCAD CAM, Inc. 866-408-3226 X147
I quite like targeted ads if they're not intensely annoying so I'll enable ads when your advertisers stop using annoying sounds, annoying slideshows and annoying animations