Need Help! cutting strategy


Results 1 to 6 of 6

Thread: cutting strategy

  1. #1
    Member
    Join Date
    Feb 2009
    Location
    USA
    Posts
    183
    Downloads
    0
    Uploads
    0

    Default cutting strategy

    in the 3 pics, one side I am going to remove the material from one side as shown with the tool path, then I am going to turn the piece 45 degrees and need to cut the small groves. how do I cut the grooves without cutting so much air?

    Similar Threads:
    Attached Thumbnails Attached Thumbnails cutting strategy-screenshot-2019-07-19-08-57-41-a   cutting strategy-screenshot-2019-07-19-09-00-15-a   cutting strategy-screenshot-2019-07-19-09-18-13-a  
    Last edited by dlaery; 07-19-2019 at 10:50 AM.
    David L. Aery
    www.hooksolutions.com


  2. #2
    Member
    Join Date
    Feb 2013
    Location
    United Kingdom
    Posts
    659
    Downloads
    0
    Uploads
    0

    Default Re: cutting strategy

    Run the simulation and save the stock out as a solid model, import this as the stock for the next op.

    I quite like targeted ads if they're not intensely annoying so I'll enable ads when your advertisers stop using annoying sounds, annoying slideshows and annoying animations


  3. #3
    Member
    Join Date
    Feb 2009
    Location
    USA
    Posts
    183
    Downloads
    0
    Uploads
    0

    Default Re: cutting strategy

    Wow, thanks!
    I never would have thought of doing it that way.

    David L. Aery
    www.hooksolutions.com


  4. #4
    Member
    Join Date
    Feb 2009
    Location
    USA
    Posts
    183
    Downloads
    0
    Uploads
    0

    Default Re: cutting strategy

    ok I have 2 machine setups. In the pics the first setup the side is the top, then after it cuts the side I thought it would stop so I could re-position the part when it goes from one machine setup to the next but it did not. the simulation runs as it should.

    Attached Thumbnails Attached Thumbnails cutting strategy-mold-jpg  
    David L. Aery
    www.hooksolutions.com


  5. #5
    Member
    Join Date
    Feb 2013
    Location
    United Kingdom
    Posts
    659
    Downloads
    0
    Uploads
    0

    Default Re: cutting strategy

    Quote Originally Posted by dlaery View Post
    I thought it would stop so I could re-position the part when it goes from one machine setup to the next but it did not. the simulation runs as it should.
    You can manually edit and add in a stop command at the end of the code from the first setup.
    Alternatively post your two setups as separate programs.

    I quite like targeted ads if they're not intensely annoying so I'll enable ads when your advertisers stop using annoying sounds, annoying slideshows and annoying animations


  6. #6
    Member
    Join Date
    Feb 2009
    Location
    USA
    Posts
    183
    Downloads
    0
    Uploads
    0

    Default Re: cutting strategy

    ok, thanks, I'll try that.

    David L. Aery
    www.hooksolutions.com


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

cutting strategy

cutting strategy