Post for Hardinge CHNC 1 with Siemens 810-T

[Machineit]

Hi all,

Typical problems with BobCad today. Fire it up to use and all the license stuff has gone away and my post for my Lathe is missing too. I re-activated my license but still need a Lathe post for my Hardinge CHNC 1 with Siemens 810-T control.

Anyone who can help would be appreciated.

Thanks---Mike

Similar Threads:

• Need Help!- Hardinge CHNC 1 with Hardinge Bar Feeder Trouble
• Need Help- Hardinge CHNC II
• HARDINGE CHNC II
• Hardinge CHNC

[The Engine Guy]

Hi Mike

I still have a support plan so I was able to download a PP for you, there was only one on the list for the Seimens 810T control so I hope the attached PP is what you need.

If you had done some "tweaks" then I`m afraid you will have to do them all again

Regards
Rob

[Machineit]

Much Thanks Guy, I'll give it a whirl.

[magicniner]

Guys,
You only need the free Customer Access level of support to download post processors, either use the Sign Up button on the left or the Register link below the Log In box on the right,
Regards,
Nick