- Importing nc-code/g-code from F-Engrave to Biesseworks
-
Member
Importing nc-code/g-code from F-Engrave to Biesseworks
I'm running Biesseworks 3.4. I'm successfully able to import dxf files for 2D vector carvings.
I would also like to do V-carving and F-engrave seems like a promising software tools for this.
https://www.scorchworks.com/Fengrave/fengrave.html
F-engrave generated gcode-files which many of the smaller/cheaper CNC machines seem to read without problem.
However, I have not been able to import these files into Biesseworks. Biesseworks claim to read "NC" files, but complains about an unknown format when I try to do a "manual import".
I know gcode comes in many flavors. Has anyone successfully been able to import gcode from F-engrave into Biesseworks?
Similar Threads:
-
-
Member
Re: Importing nc-code/g-code from F-Engrave to Biesseworks
Biesse has very specific ISO format, if you don't have some postprocessor, you can't do that :-(
What you could try is to generate NC code from Biesse works editor (programmed some similar panel) and manualy (with Wordpad or similar texteditor) insert the G-code in the right section. But you can't open it in Biesse works editor, only in old Program editor (under CNI WRT), where you can check the functionality.
- Importing nc-code/g-code from F-Engrave to Biesseworks
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules