- AMADA OP2000 CONTROL LOADING LARGE RADIUS TOOL
-
Member
AMADA OP2000 CONTROL LOADING LARGE RADIUS TOOL
I need to load a 1" radius punch in my tool library. What do you use for the angle input.
I tried 90 degree at first but then got a mismatch error because the large V die i'm using is
85 degree and has a 2.480" V opening. It did run but my bend angle was way off.
anyone running this control that can help?
Similar Threads:
-
- AMADA OP2000 CONTROL LOADING LARGE RADIUS TOOL
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules