Help Question: Amada RG-100 with a NC9-EXii Controller showing Alarm 2

Results 1 to 1 of 1

Thread: Help Question: Amada RG-100 with a NC9-EXii Controller showing Alarm 2

  1. #1

    Default Help Question: Amada RG-100 with a NC9-EXii Controller showing Alarm 2

    I have an operator who says his press brake has went into alarm while he was a way a couple of times last week. He says he comes back and the alarm light is flahing and it only shows a 2 in the alarm readout. I am waiting for it to happen so that I can "see" what the alarm actually reads. Has anyone experienced it before?


    Thanks

    Ken

    Help Question: Amada RG-100 with a NC9-EXii Controller showing Alarm 2-brake-alarm-jpg

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Help Question: Amada RG-100 with a NC9-EXii Controller showing Alarm 2-brake-alarm-jpg  
    Last edited by kennadrin; 02-12-2021 at 11:05 AM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Help Question: Amada RG-100 with a NC9-EXii Controller showing Alarm 2

Help Question: Amada RG-100 with a NC9-EXii Controller showing Alarm 2