- Trumpf TC260R cannot reaches reference on C axis
-
Trumpf TC260R cannot reaches reference on C axis
Dear community
After a sheet crash the machine was sent to home. But something stuck the C axis (upper punch head). We disassembly part of the head and have it spinning again and aligned since by the stuck the position was about 30 degrees out of center.
Now when reference axis the C axis goes to 0.039 or 360.040 but can’t get the * as the rest of the axis to get fully referenced. No error on screen only the machine trying to reach reference on C.
Any ideas
BYW I have tried to adjust with Zero Adjustment on indramat amplifier but no success
Thanks in advance for your help
-
-
Member
Re: Trumpf TC260R cannot reaches reference on C axis
You have to adjust the reference offset
- Trumpf TC260R cannot reaches reference on C axis
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules