- Problem- ball screw replace for Chinese cnc 6040z
-
Member
ball screw replace for Chinese cnc 6040z
Does anybody know the dimensions for X axle ballscrew cnc 6040z?
As i understand it is sfu1605, however it's length is 760mm, i can not find any sfu1605 with that length.
Similar Threads:
-
-
Member
Re: ball screw replace for Chinese cnc 6040z
Some sellers will cut the ballscrew and machine the ends to your specification. Or you could buy a longer ballscrew and find a local machinist to cut it.
P. S. "6040z" is a pretty generic term, so measurements from someone else's machine may or may not be correct for yours.
-
Member
Re: ball screw replace for Chinese cnc 6040z
@sashaKR
You should pull out the screw and make the drawing- the way ball screws are supplied are as plain screws with a ball nut based on your selection. We normally specify the end dimensions which the ball screw supplier then machines and grinds and then gives to us. (I've purchased at least 20 ball screws till date)
Best of luck!
Jaideep
-
Member
Re: ball screw replace for Chinese cnc 6040z
Thank you for your replies.
I understand that ball screw can be manufactured almost any dimension, however i was hoped that for standard cnc, standard ball screw should be enough. There are so many parameters, therefore i don't want to risk and put an order with my measurements. I've seen a lot of standard sfu1605, sfu1610 - so i hoped there should be standard for my cnc as well
-
-
Member
Re: ball screw replace for Chinese cnc 6040z
And buy a ballscrew already machined. Well, in New Zealand, the people who can machine ballscrews just quoted me NZ$250 for one. Yep.
Sent from my SM-N970F using Tapatalk
- Problem- ball screw replace for Chinese cnc 6040z
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules