Hi Ambico,
Did you resolve your problems? I just got the same system and having the same problems you describe, so if you have a solution, or more ways to trouble shoot it, it would be very much appreciated.
Automation Technologies gave me the following settings for my motors, but these are the 500 inch ounce motors.
dip switch settings
1 OFF
2 OFF
3 OFF
4 ON
5 ON
6 OFF
7 ON
8 ON
When I turn on the system, the motors energize and go into holding mode, but I cannot get them to move. I have tried the mach 3 config files from Automation Technologies and from the cnc4pc websites with no luck.
Regards,
Gary