EMCO PCTURN 55 Post Processor

[mustangdan]

Good day everyone,
I have an "old" Emco PCTURN 55 lathe and am trying to get HSMWORKS 2016 to post out in a proper format which my lath will use. I have done a fair share of manually writing the code but it is not as quick of course and using a program to write the code.

Can anyone help me out with a post processer that will work? HSMWORKS is to my understanding quite close to Fusion360.

Thank you.....

[mactec54]

[QUOTE=mustangdan;2538203]Good day everyone,
I have an "old" Emco PCTURN 55 lathe and am trying to get HSMWORKS 2016 to post out in a proper format which my lath will use. I have done a fair share of manually writing the code but it is not as quick of course and using a program to write the code.

Can anyone help me out with a post processer that will work? HSMWORKS is to my understanding quite close to Fusion360.

Thank you.....[/QUOTE]

You have the G-Code format that works for you lathe, so just choose a postprocessor that outputs close to what you need, then edit it with the postprocessor editor in HSMWORKS, I'm sure there are also video on how to use their editor.

[mactec54]

Here is how to use the Editor.

[mustangdan]

Thank you!