Still looking it?
Hello all,
I have searched the world over for a post processor for Siemens 840c lathe and Fusion 360. I have not been able to modify an existing one to be worth while using. I am sure that there is alot of these combinations in use. Does anyone have a solution?
I have the PC and the machine communicating just fine. I am happy to share that setup if it helps anyone.
Thanks in advance to anyone compelled to help, In the meantime, I am just going to poke the buttons the old school way.
Trevor
Similar Threads:
Still looking it?
Postprocessors, VBA macros, .NET programming.
www.ccsoftcz.com
Yes, I would still like to find a good post processor for this combination. Thanks
Please send me NC code example to my email [email]msskotak@gmail.com[/email].
I will check it.
Postprocessors, VBA macros, .NET programming.
www.ccsoftcz.com