Newbie Issue with fillet machinning using mach3 and fusion


Results 1 to 2 of 2

Thread: Issue with fillet machinning using mach3 and fusion

  1. #1
    Member remi2103's Avatar
    Join Date
    Jun 2020
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Issue with fillet machinning using mach3 and fusion

    Hello
    I run small wood job on CNC.
    I just got a new CNC which is controlled with MACH3.
    I was used to run a GRBL controlled CNC (Shapeoko)

    I post processed an existing cam i already runned on my shapeoko with the mach3mill post processor.
    everything was ok until i had to machin fillets.

    The fillets are not on the good place, like if flat part of my tool were ignored.
    I had no problem on my shapeoko with the same toolpathes.
    it is a 2D contour toolpath with fillet bit.
    anyone has a clue ?
    you can see différences fusion VS reality in the attached photos.
    thank you
    Remi

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Issue with fillet machinning using mach3 and fusion-fusion-jpg   Issue with fillet machinning using mach3 and fusion-mach3-jpg  


  2. #2
    Member remi2103's Avatar
    Join Date
    Jun 2020
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Issue with fillet machinning using mach3 and fusion

    after verification i noticed that the tool tip diameter of my roundover bit changed by himself for unknown reason.

    all is fine with good setting.

    thank you



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Issue with fillet machinning using mach3 and fusion

Issue with fillet machinning using mach3 and fusion

Issue with fillet machinning using mach3 and fusion