- FANUC ATC ON FSSB BUS
-
Member
FANUC ATC ON FSSB BUS
Good Morning All,
I just started at a shop and one of the machines tool changer is down.
Drive does not have coms or ready light on.
Going through the manual to align the tool changer pot 1 position it mentions to jog A Axis
And Reference the Axis in PAR 1015
Par 1015 only has XYZ and not A axis
Does the tool changer Utilize "A" Axis?
Other machines don't seem to have it ( but they seem to use the io link interface VS FSSB)
Thanks in advance
Wes
Similar Threads:
-
- FANUC ATC ON FSSB BUS
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules