Mazak 410A alarm 302 atc arm driver malf

Results 1 to 3 of 3

Thread: Mazak 410A alarm 302 atc arm driver malf

  1. #1
    Member
    Join Date
    Sep 2016
    Location
    United States
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Mazak 410A alarm 302 atc arm driver malf

    Can anyone tell me how to fix this alarm? We get it when we try a tool change. The magazine will index a tool and it stops and we get this alarm. We get it in the early morning. After running for an hour so the machine warms up and runs fine. Oil levels are good

    thanks, for your help, Mike

    Similar Threads:


  2. #2
    Member
    Join Date
    Sep 2017
    Location
    Bahrain
    Posts
    128
    Downloads
    0
    Uploads
    0

    Default Re: Mazak 410A alarm 302 atc arm driver malf

    Could you list the full alarm description along with codes mentioned in brackets. Else please check the alarm details in MR-J2 software, or please check the alarm coder on 7-segment display on the drive unit



  3. #3
    Member
    Join Date
    Sep 2016
    Location
    United States
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Mazak 410A alarm 302 atc arm driver malf

    Well it turns out the drive was bad. It had a thermal issue that caused it to not work when it was cold. After the machine warmed up we sprayed it with a can of freeze dry and it caused the alarm again. That's how we found it. Took and re soldered all the board connections on the drive and it works fine now.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Mazak 410A alarm 302 atc arm driver malf

Mazak 410A alarm 302 atc arm driver malf

Mazak 410A alarm 302 atc arm driver malf