Double Arm Vertical alignment issue (Okuma Howa Millac 3VA)

Results 1 to 1 of 1

Thread: Double Arm Vertical alignment issue (Okuma Howa Millac 3VA)

  1. #1
    Member
    Join Date
    Aug 2010
    Location
    Texas
    Posts
    57
    Downloads
    0
    Uploads
    0

    Question Double Arm Vertical alignment issue (Okuma Howa Millac 3VA)

    Hi all,

    I had a small crash earlier today. Nothing seems too wrong except the arm is now too low for the pot in the carousel. I've included a picture of the ATC arm at the toolpot in the carousel to show you what I mean. Is there a way to adjust the arm up and down? I only want to have to figure it out the hard way if I absolutely have to.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Double Arm Vertical alignment issue (Okuma Howa Millac 3VA)-20190517_133757-1-jpg  
    Last edited by sabine; 05-17-2019 at 03:53 PM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Double Arm Vertical alignment issue (Okuma Howa Millac 3VA)

Double Arm Vertical alignment issue (Okuma Howa Millac 3VA)