rino ondrive rotary and uccnc help plse

[curiosity22]

I have dugout my tiny rino ondrive for my 4th axix to test. Im reading the ucnc manual but am a bit lost. For the life of me I cant work out how to set it up.

If anyone has some time to give me a hand please.

cheers,
steve

Similar Threads:

• New Product- Inside A Low Backlash Worm Gear from Rino Ondrive 4th Axis Video
• UCCNC and rotary axis
• UCCNC - Rotary (4th Axis)
• rino cam
• books on rino

[curiosity22]

Ok making some progress (sorta) the stepper motor gets hot reasonably quickly... sigh so I have to disconnect it before I can run a calibration. Stepper is a C014S-9212K VEXTA 1/8 /step DV 5V 1.4A ....

One issue I had with getting a peep from it was, the Y still had the Slave setting on in UCCNC... mind you I'm still lost... LOL

I've taken the stepper off the wormdrive for now, it seems to be ok, I tested it with an led quick turn either way both wires led lights up. I thought I may have damaged it.

I thought I could run a 5v stepper from the G540 maybe I am mistaken...

Any clues ???

I have tried dr google but that model number stepper to find at least an equivalent to it but not much luck..

Cheers,
Steve

[ger21]

You probably need an appropriate current set resistor to limit the current to 1.4 amps.

[curiosity22]

Hey Gerry G'day,

Thank you for that tip, that would be the small tuning dial in the db9 correct? Its been such a long time since Ive had to think about doing any changes, my mind is getting old.

Thank you for taking the time much appreciated.

Steve

[ger21]

Thank you for that tip, that would be the small tuning dial in the db9 correct?

That sounds like an aftermarket item, but I think so.

[curiosity22]

That sounds like an aftermarket item, but I think so.

homanndesigns sells them and they are a part of the db9 standard plugs you get with the g540 as I understand it. I didn't think about it at all, not like you crack them open every day. https://www.homanndesigns.com/index....roducts_id=343. I ordered a few from Peter yesterday, so will be a day or so before they arrive.

Mind you I think I've buggered the stepper anyways, I have a little arduino 3 axis controller, not a peep.

Will see next couple of days.

Thank you for taking the time.

Cheers,
Steve