Xilog/Maestro/Aspire issue

[toymaker2]

Hi
I have a problem running aspire on my SCM pratix S12.As seen in the videoclip there is an extra z movment in between two toolpaths, there is, in the ISO-file produced by MAESTRO a couple of rows that is + or - 140 mm, these rows are not in the XXL file produced by my Aspire postprocessor. Most likely these movements are added somewhere in the translation process XXL>PGM>PGMX>ISO but I cant figure out where it come from. I tried to attach the XXL/ISO files but I dont know if I succeeded.
Any help would be highly appreciated.

[ger21]

On our Morbidelli X200, I've run one file that I created in Aspire, and imported into Maestro, and I believe that I saw a similar issue. I was running the .pgmx file directly, but didn't see anything in Maestro that could cause it. Never spent too much time looking into it, as I was only running one file.
I usually just program everything in Maestro after importing .dxf files.

[joeeatfood]

Please upload the XXL or pgm file.

[toymaker2]

Here is xxl and pgm

[toymaker2]

Sorry, I meant ISO, the PGM is too big to attach.